LEXUS RX 300

1998 — 2003 of release

Repair and operation of the car



Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
- Brake system
   General information and security measures
   Removal, installation and check of pedals of the brake system
   Check of the brake system via the socket of the module of management
   Removal and installation of the tank and main brake cylinder (MBC)
   Removal, check and installation of the amplifier of brakes
   Replacement of brake shoes
   Removal, dismantling, check, assembly and installation of supports of brake mechanisms
   Dismantling, check and assembly of the parking brake
   Valve check of distribution of brake effort
   Removal and installation of the activator of brakes
   Removal and installation of wheel sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections


2598ff35

Replacement of brake shoes

The description of check of brake shoes is provided in the Section the General checks of the brake system.

Assembly of the forward brake mechanism

1 — the pumping Union
2 — the Support
3 — Laying
4 — the Directing pin
5 — the Piston
6 — Consolidation of the piston
7 — a piston Cover
8 — a piston cover Ring
9 — the Directing plug

10 — the Boot
11 — the Brake disk
12 — a support Bracket
13 — Holders of brake shoes
14 — the Indicator plate of wear of blocks
15 — Antivizgovaya a slip
16 — the Internal antivizgovy slip
17 — the Internal brake shoe
18 — the External brake shoe


 PERFORMANCE ORDER

  1. Assembly of the brake mechanism of a back wheel is given in the illustration Assembly of the Back Brake Mechanism.
  2. Remove the corresponding wheel and temporarily fix a brake disk by wheel nuts.
  3. Turn out a bolt of fastening of a support, cast away a support and reliably tie up it.

Do not disconnect flexible hoses from a support.

  1. Remove 2 brake shoes with four antivizgovy overlays and an indicator plate of wear of blocks.
  2. Remove 2 holders of brake shoes.

Not deformed holders it is possible to reuse.

  1. Check a condition of a brake disk (see the Section the General checks of the brake system).
  2. Installation is made as it should be, the return to an order of dismantle of components. Turn removal on the following remarks:
    • At installation of new blocks establish as well new antivizgovy slips;
    • Grease both parties of internal antivizgovy slips with special lubricant for brakes;
    • Do not allow hit of oil and lubricant on frictional overlays of brake shoes;
    • At installation of a support wring out the piston, for example, the hammer handle if the piston goes hardly, weaken the pumping union to allow to flow out brake fluid;
    • Delay all connections with the required efforts.


(adsbygoogle121 = window.adsbygoogle121 || []).push({});