1998 — 2003 of release

Repair and operation of the car

Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
- Transmission line
   General information
   Removal and installation of the driveshaft
   Removal, dismantling, assembly and installation of forward power shafts
   Removal, dismantling, assembly and installation of back power shafts
   Replacement of a forward epiploon of back differential
   Replacement of side epiploons of back differential
   Removal and installation of the case of back differential, dismantling of differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections


Replacement of side epiploons of back differential

Components of installation of side epiploons of back differential

1 — Laying
2 — the Stopper of a jellied opening
3 — the Power shaft

4 — the Lock ring
5 — the Epiploon
6 — Side transfer
7 — the Drain stopper


  1. Lower oil of back differential.
  2. Remove a power shaft, previously reliably having propped up it (see the Section Removal, dismantling, assembly and installation of back power shafts).
  3. By means of special adaptation remove side transfer of differential and remove from it the screw-driver a lock ring.
  4. By means of a special stripper take an old epiploon and press new aflush with an end face of its case.
  5. Apply universal lubricant on epiploon edges.
  6. Establish a new lock ring on tank transfer and establish transfer to differential.
  7. Make sure that side transfer of differential cannot be pulled out a hand, without special adaptation.
  8. Establish a power shaft and fill differential with oil according to requirements of Specifications of the Head the Transmission line.

(adsbygoogle121 = window.adsbygoogle121 || []).push({});