LEXUS RX 300

1998 — 2003 of release

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
- Automatic transmission and interaxal differential
   General information
   Search of malfunctions - the general information
   Replacement of sensors
   Removal and installation of assembly of AT valves
   Checks and adjustments of AT
   Removal and installation of a cooler of ATF
   Removal and installation of assembly of the lever of the selector of the AT modes
   Removal and AT installation
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections

2598ff35

Removal and AT installation

Components of the AT (U140F) installation

1 — the Plait and sockets of an electrical wiring
2 — a weight Cable
3 — the Right support
4 — the Right rack of an exhaust pipe
5 — Transmission

6 — an opening Stopper for measurement of pressure in the AT lines
7 — the Starter
8 — the Left rack of an exhaust pipe
9 — the Lower cover of a driving disk


 PERFORMANCE ORDER

  1. Remove the power unit from the car (see the Section Removal and installation of the engine, check of support).
  2. Remove a starter (see the Section Removal and installation of a starter).
  3. Turn out bolts and nuts and remove the left and right racks of an exhaust pipe.
  4. Turn out 5 bolts and remove the right support.
  5. Turn out 2 bolts the lower cover of a driving disk.
  6. Turning a bent shaft, turn out bolts of fastening of the coupling of the hydrotransformer.
  1. Turn out three lower bolts of fastening of AT.
  1. Turn out bolts of fastening of cables of weight to AT and disconnect these cables.
  2. Disconnect the following sockets from AT:
    • D/V socket of the P / N mode;
    • Electrical wiring socket Ý/m valve;
    • Socket of the sensor of entrance turns of the hydrotransformer;
    • Socket of the sensor of speed of an auxiliary gear wheel.
  3. Release an electrical wiring plait from holders.
  4. Turn out 5 top bolts of fastening of AT and disconnect a weight cable.
  5. Remove AT.
  6. Installation is made upside-down. Tighten fixture with the required effort.
  7. After installation adjust the drive of gear shifting and D/V of the P / N modes. Fill AT with ATF liquid, check its level. Make a trial trip on the car.


(adsbygoogle121 = window.adsbygoogle121 || []).push({});