Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
- Automatic transmission and interaxal differential
General information
Search of malfunctions - the general information
Replacement of sensors
Removal and installation of assembly of AT valves
Checks and adjustments of AT
Removal and installation of a cooler of ATF
Removal and installation of assembly of the lever of the selector of the AT modes
Removal and AT installation
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections
|
Replacement of sensors Speed sensors
|
|
- Disconnect a negative wire from the rechargeable battery.
- Remove assembly of the air cleaner (see the Head of the Power supply system and production of the fulfilled gases).
- Separate sockets of an electrical wiring of the sensor of entrance turns of the hydrotransformer and the sensor of speed of a secondary gear wheel, turn out bolts of fastening of sensors and remove sensors.
|
|
- Sensor of entrance turns of the hydrotransformer
|
|
|
- Sensor of speed of a secondary gear wheel
|
- Install new sensors together with new sealing rings and tighten bolts of fastening of sensors with effort of 11 Nanometers.
|
|
ATF temperature sensor
|
|
- Remove assembly of valves (see the Section Removal and installation of assembly of AT valves).
|
|
- Separate the electrical wiring socket Ý/m the valve, turn out a bolt, remove a wire of the valve and remove ATF temperature sensor.
|
- Install the new sensor, tighten a fixing bolt with effort of 5.4 Nanometers and connect an electrical wiring.
|
|
Sensor switch of the P / N modes
|
|
- Remove the lower protection cover of a motive compartment.
|
|
- Separate the socket of an electrical wiring of D/V of the modes "P"/" N". Give nuts, remove a washer and the lever of draft of switching of the modes.
|
|
|
- Wring out a lock plate, turn out the lower nut and remove a lock plate.
|
|
|
- Turn out bolts of fastening of D/V of the P / N modes and remove the sensor switch.
|
- Establish new D/V and tighten bolts of its fastening with effort of 5.4 Nanometers.
- Tighten the lower nut with effort of 6.9 Nanometers and record it a lock washer, having bent its edges.
- Tighten the top nuts with the required efforts and join the sensor socket.
- Check that the engine is started only at the AT selector lever installed in situation "P" or "N". If necessary adjust D/V (see the Section of Check and adjustment of AT).
- Establish assembly of the air cleaner and the lower protection cover of a motive compartment.
|
|
|
(adsbygoogle121 = window.adsbygoogle121 || []).push({});
|
