Lexus RX 300 + Lexus RX-300 cars + Governing bodies and methods of operation + Settings and routine maintenance of the car + Engine + Cooling systems of the engine, heating, ventilation and air conditioning + A power supply system and production of the fulfilled gases + Systems of electric equipment of the engine - Automatic transmission and interaxal differential General information Search of malfunctions - the general information Replacement of sensors Removal and installation of assembly of AT valves Checks and adjustments of AT Removal and installation of a cooler of ATF Removal and installation of assembly of the lever of the selector of the AT modes Removal and AT installation + Transmission line + Brake system + Suspension bracket and steering + Body + Onboard electric equipment + Schematic diagrams of electric connections
|
Removal and installation of assembly of AT valves
|
|
- Remove the lower protection cover of a motive compartment, turn out a drain stopper and empty AT.
|
- Turn out 18 bolts of fastening of the pallet of a case of AT, remove the pallet and disconnect from it laying.
- Remove magnets and collect with their help metal particles from AT case pallet. Examine metal particles on a magnet and on the pallet – the steel particles which are (magnetized) indicate wear of bearings, gear wheels and washers, but not magnetized (copper or brass) – wear of plugs.
|
- Turn out 3 bolts and remove a maslozabornik with a sealing ring.
|
- Separate sockets of five Ý/m switching valves.
- Turn out a bolt, remove a lock plate and remove ATF temperature sensor (see the Section Replacement of Sensors).
- Release an electrical wiring from two holders.
|
- Turn out 17 bolts and remove assembly of valves.
|
|
Do not drop assembly of the control valve, a spring and the piston of the accumulator. |
|
- Remove the case of the control valve, a spring and three laying.
|
|
- Turn out 5 bolts and remove 5 Ý/m switching valves.
|
- Installation is made as it should be, the return to an order of dismantle of components, tighten fixture with the required efforts, use new laying and sealing rings.
|
|
|
(adsbygoogle121 = window.adsbygoogle121 || []).push({});
|