LEXUS RX 300

1998 — 2003 of release

Removal, dismantling, assembly and installation of front seats

Components of assembly of a front seat


1 — the Head restraint 2 — head restraint Support 3 — the Armrest 4 — the Electrical wiring 5 — the Back 6 — a back Frame 7 — a back Cover 8 — the Heating element of a back 9 — Assembly of a lumbar support 10 — the Cover 11 — a back Cover	12 — the Cutting washer 13 — a pillow Cover 14 — the Pillow 15 — the Heating element of a pillow 16 — a pillow Frame 17 — the belt Lock 18 — a guide Cover 19 — Internal covers of a pillow 20 — the pillow Panel 21 — a pillow Cover 22 — the Forward cover of a pillow 23 — Buttons of management of the provision of a seat

Components э / drive of a front seat


1 — Assembly of the mechanism of adjustment of an inclination 2 — Assembly of vertical draft No. 2 3 — Switches of management of the provision of a seat 4 — Э / the motor of the drive of the mechanism of adjustment of an inclination 5 — Э / the motor of the drive of raising of a forward part of a pillow 6 — an electrical wiring Plait	7 — the Relay of management of the provision of a seat 8 — Assembly of vertical draft 9 — Intensifying draft 10 — Э / the motor of the drive of raising of a back part of a pillow 11 — a guide Cover 12 — Э / the motor of the drive of movement of a seat 13 — Assembly of the mechanism of movement of a seat

PERFORMANCE ORDER

Uncover guides by means of the screw-driver.
Turn out 4 bolts, separate sockets and remove a front seat.
Remove head restraints.
Remove buttons of management of the provision of a seat, turn out 4 screws and remove the seat pillow panel, having separated the electrical wiring socket.
Turn out 3 screws and uncover a seat pillow.
Turn out 2 screws and remove a forward cover of a pillow of a seat.
Remove an electrical wiring from assembly of a pillow, turn out 4 bolts, and remove assembly of a pillow of a seat.
Remove cutting washers, unhook hooks of a cover of a pillow and remove a cover together with a pillow.
Remove cutting washers and disconnect a cover from a seat pillow, if necessary remove a heating element of a pillow.

Do not pull an electrical wiring of a side safety cushion.

Turn out 6 screws and remove internal covers of a pillow of a seat, having disconnected from them an electrical wiring.
Remove assembly of a seatback.
Remove cutting washers, turn out 2 screws, unhook the holder and a hook of a cover of a back from a back frame.
Remove caps of bolts, washers, wavy washers and armrests.
Remove a back frame.
On a driver's seat turn out 2 bolts and remove assembly of a lumbar support.
Remove cutting washers and disconnect a cover from a seatback, if necessary remove a heating element of a back.
Turn out a bolt and remove the seat belt lock.
Turn out 2 screws and remove switches of management of the provision of a seat.
Separate sockets and remove an electrical wiring.
On a driver's seat give 2 nuts and remove the relay of management of the provision of a seat and intensifying draft.
Uncover guides, give 2 nuts and remove a seat belt arm.
Remove assembly of the mechanism of adjustment of an inclination of a back together with assembly of vertical draft No. 2 (only on the driver's seat) and э / the motor of this mechanism.
On a driver's seat remove vertical draft, vertical draft No. 2 and э / motors of the drive of raising of forward and back parts of a pillow.
Remove э / the motor of the drive of movement of a seat.
Assembly and installation are made upside-down. Tighten fixture with the required efforts.