LEXUS RX 300

1998 — 2003 of release

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
- Suspension bracket and steering
   General information
   - Forward suspension bracket
      Removal, dismantling, assembly and installation of a nave and rotary fist
      Removal, dismantling assembly and installation of a rack of a suspension bracket
      Removal and installation of the lower lever of a suspension bracket
      Check and replacement of a spherical support of a suspension bracket
      Removal, installation and check of the stabilizer of a suspension bracket
   + Back suspension bracket
   + Steering
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections

2598ff35

Removal, installation and check of the stabilizer of a suspension bracket

Components of installation of the stabilizer of a forward suspension bracket

1 — a stabilizer Rack
2 — the Bracket
3 — the Plug

4 — a plug Stopper
5 — the Bracket No. 2
6 — the Holder of a stopper


 PERFORMANCE ORDER

  1. Remove both forward wheels.
  2. Turn out two nuts from each party and remove both racks of the stabilizer (serially).

If hinges are turned together with nuts, hold them a six-sided key on 5 mm.

  1. Serially turn out two bolts and remove brackets and plugs of the stabilizer.
  2. Remove the stabilizer.
  3. By means of the screw-driver remove the holder of a stopper of the plug, and then remove a stopper.
  1. Clamp the hinge of a rack of the stabilizer in a vice and shake its tip back and forth about five times.
  1. Continuously tightening a dynamometer key a hinge nut with a speed of 1 a turn for 2 ÷ 4 with, consider indications of a key on the fifth turn and compare them to requirements of Specifications of the Head Podvesk and steering. If necessary replace a stabilizer rack.
  2. Installation is made upside-down. Install the plug of the stabilizer outside of a plug stopper; install the stabilizer by the party marked with paint to the left board of the car.