LEXUS RX 300

1998 — 2003 of release

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
- Suspension bracket and steering
   General information
   + Forward suspension bracket
   + Back suspension bracket
   + Steering
   - Suspension bracket geometry
      The angles of installation of wheels of the car - the general information
      Check and adjustment of angles of installation of forward wheels
      Check and adjustments of angles of installation of back wheels
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections

2598ff35

Check and adjustments of angles of installation of back wheels

Check

 PERFORMANCE ORDER

  1. Measure suspension bracket height (see the Section Check and adjustment of angles of installation of forward wheels).
  2. Install the car on the measuring stand and check disorder and convergence of back wheels.
  3. If the size of disorder do not conform to requirements of Specifications of the Head Podvesk and steering, check suspension bracket components for existence of damages and wear.

Disorder of back wheels is not regulated.

  1. If the size of convergence do not conform to requirements of Specifications of the Head Podvesk and steering, adjust convergence.

Convergence adjustment

 PERFORMANCE ORDER

  1. Measure distance from a disk of each back wheel to a corner of the clown of adjustment of convergence.
  1. If a difference between the measured distances more than 3.0 mm, weaken a bolt of the clown and turn the clown on the corner demanded for installation of average specification value of convergence.
  1. After adjustment tighten a bolt with effort of 113 Nanometers.


(adsbygoogle121 = window.adsbygoogle121 || []).push({});