LEXUS RX 300

1998 — 2003 of release

Repair and operation of the car



Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ Power supply system and production of the fulfilled gases
- Systems of electric equipment of the engine
   + Systems of ignition and engine management
   + Diagnostics of systems of electronic control and diagnostic equipment
   - Systems of a charge and start
      General information
      The rechargeable battery - the general information, recommendations about service
      System of a charge - general information and security measures
      Check of system of a charge
      Removal and installation of the generator
      System of start of the engine - the general information
      Removal and installation of a starter
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections


2598ff35



Removal and installation of the generator

Details of installation of the generator

1 — the Flat washer
2 — the Hinged bolt
3 — the Fixing bolt of adjustment of a tension of a driving belt
4 — a generator Wire

5 — the generator Socket
6 — the Generator
7 — the Bolt of adjustment of a tension of a driving belt of the generator
8 — the Driving belt of the generator and K/V compressor

Details of assembly of the L3B generator

1 — a generator Washer
2 — a bearing Cover
3 — the Back bearing
4 — the Rotor
5 — the Forward bearing
6 — the Holder
7 — the Cover from the drive

8 — the Pulley
9 — the Back sealing plate
10 — the Forward sealing plate
11 — the Insulator of contact
12 — the Brush holder
13 — the Back cover
14 — Assembly of a winding

Details of assembly of the SC1 generator

1 — the Washer the generator
2 — a bearing Cover
3 — the Back bearing
4 — the Rotor
5 — the Forward bearing
6 — the Holder
7 — the Stator (a cover from the drive)
8 — the Pulley
9 — the Plug
10 — a brush holder Cover

11 — the Insulator of contact
12 — the Sealing plate
13 — an electrical wiring Clip
14 — the Cover from the rectifier
15 — the Back cover
16 — the Brush holder
17 — tension Regulator
18 — the Holder of the rectifier
19 — the Rubber insulator


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Take off a driving belt (see the Head Nastroyki and routine maintenance of the car).
  3. Separate the generator socket.
  4. Give a nut and disconnect a wire from the generator.
  5. Disconnect an electrical wiring plait from the holder.
  6. Turn out a hinged bolt, remove a flat washer, the fixing bolt of adjustment of a tension of a driving belt and the generator.
  7. Installation is made as it should be, the return to an order of dismantle of components.