LEXUS RX 300

1998 — 2003 of release

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
- Brake system
   General information and security measures
   Removal, installation and check of pedals of the brake system
   Check of the brake system via the socket of the module of management
   Removal and installation of the tank and main brake cylinder (MBC)
   Removal, check and installation of the amplifier of brakes
   Replacement of brake shoes
   Removal, dismantling, check, assembly and installation of supports of brake mechanisms
   Dismantling, check and assembly of the parking brake
   Valve check of distribution of brake effort
   Removal and installation of the activator of brakes
   Removal and installation of wheel sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections

2598ff35

Removal, installation and check of pedals of the brake system

Check and adjustment of the course of pedals of the working and parking brake are given in the Section Check and adjustment of the course of pedals of the working and parking brake.

Components of installation of a pedal of a working brake

1 — the Plug
2 — the Pillow
3 — the Pin
4 — the Wavy washer

5 — the Pedal of a working brake
6 — the Overlay of a pedal
7 — the Forelock
8 — the Returnable spring

Components of installation of a pedal of the parking brake

1 — the Socket of the switch of the parking brake
2 — Assembly of a pedal of the parking brake
3 — the Switch of the parking brake

4 — the Pedal of the drive of the parking brake
5 — the Overlay of a pedal
6 — the Cable of the parking brake
7 — the Clip


 PERFORMANCE ORDER

  1. The description of removal of a pedal of the drive of the parking brake is given below.
  2. Remove the lower left section of the dashboard (see the Head Kuzov).
  3. Release a pedal of the parking brake.
  4. Separate the socket of an electrical wiring of the switch of the parking brake
  5. Give 3 nuts and remove assembly of a pedal of the drive of the parking brake.
  6. Remove a clip and disconnect a torso of the drive of the parking brake.
  7. Turn out the screw and remove the switch of the parking brake.
  8. Remove a slip from a pedal.
  9. Installation is made upside-down.


(adsbygoogle121 = window.adsbygoogle121 || []).push({});