LEXUS RX 300

1998 — 2003 of release

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
- Transmission line
   General information
   Removal and installation of the driveshaft
   Removal, dismantling, assembly and installation of forward power shafts
   Removal, dismantling, assembly and installation of back power shafts
   Replacement of a forward epiploon of back differential
   Replacement of side epiploons of back differential
   Removal and installation of the case of back differential, dismantling of differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections

2598ff35

Replacement of a forward epiploon of back differential

Components of installation of a forward epiploon of back differential

1 — Laying
2 — the Stopper of a jellied opening
3 — the Driveshaft
4 — the Connecting flange

5 — the Epiploon
6 — the Maslootrazhatelny ring
7 — the Forward bearing
8 — Prostavka of the bearing
9 — the Drain stopper


 PERFORMANCE ORDER

  1. Lower oil of back differential.
  2. Remove the driveshaft (see the Section of the Door).
  3. Chisel and hammer to a raschekanta nut.
  4. Holding a connecting flange by means of special adaptation, turn out a nut.
  1. Remove a connecting flange by means of special adaptation.
  1. By means of special adaptation remove an epiploon, and then – a maslootrazhatelny ring.
  1. Remove the forward bearing and by means of a special stripper, remove a bearing pro-rate.
  2. Establish a new pro-rate of the bearing and the bearing on a shaft.
  3. Establish a maslootrazhatelny ring and press a new epiploon on depth of 2.0 mm.
  4. Apply universal lubricant on epiploon edges.
  5. By means of special adaptation establish a connecting flange on a shaft.
  6. Oil a carving of a fixing nut of a flange for differential and holding a flange from a provorachivaniye, tighten a nut with effort of 108 Nanometers.
  7. Adjust a preliminary tightness of the leading gear wheel.
  8. Rivet a nut.
  9. Install the driveshaft and fill differential with oil according to requirements of Specifications of the Head the Transmission line.


(adsbygoogle121 = window.adsbygoogle121 || []).push({});