LEXUS RX 300

1998 — 2003 of release

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
- Transmission line
   General information
   Removal and installation of the driveshaft
   Removal, dismantling, assembly and installation of forward power shafts
   Removal, dismantling, assembly and installation of back power shafts
   Replacement of a forward epiploon of back differential
   Replacement of side epiploons of back differential
   Removal and installation of the case of back differential, dismantling of differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schematic diagrams of electric connections

2598ff35

Removal and installation of the driveshaft

Driveshaft components

1 — Forward section of the driveshaft
2 — the Boot
3 — the Bearing of a back support
4 — Plastina
5 — the Adjusting washer
6 — the Bearing of a forward support

7 — the Washer
8 — Intermediate section of the driveshaft
9 — the Back flange
10 — the Forward flange
11 — Back section of the driveshaft

Removal

 PERFORMANCE ORDER

  1. Apply adjusting tags on a forward flange and on the hinge.
  1. Give 4 nuts and remove bolts and washers.
  2. Remove assembly of forward section of the driveshaft, trying not to damage an epiploon.
  3. Zakuporte an opening in AT to prevent oil leak.
  4. Squeeze out a pedal of a brake and hold it in this situation.
  5. Turn out 6 connecting bolts half way.

Fill rags that it did not concern a cover in the hinge.

  1. Apply adjusting tags on a back flange and on the hinge.
  2. Give 4 nuts and remove bolts and washers.
  3. Turn out bolts of fastening of support and remove assembly of the central and back sections of the driveshaft.
  4. Apply tags on connection of the central and back sections of the driveshaft.

You do not put a tag with a chisel.

  1. Completely turn out 6 connecting bolts, remove two washers and divide the central and back sections of the driveshaft.

Installation

 PERFORMANCE ORDER

  1. Join the central and back sections of the driveshaft, having leveled the adjusting tags applied on them at separation.
  2. Establish two washers and tighten by hand 6 connecting bolts.
  3. Temporarily install the central basic bearing.
  4. Level the tags applied at removal on the back hinge and on back differential.
  5. Tighten 4 bolts with effort of 74 Nanometers.
  6. Take out a cap from AT and establish a holder.
  7. Level the tags applied at removal on the forward hinge and on intermediate section of the driveshaft.
  8. Tighten 4 bolts with effort of 74 Nanometers.
  9. Squeeze out a pedal of a brake and having asked the assistant to hold it, tighten connecting bolts with effort of 27 Nanometers.
  1. Make sure that all hinges of the driveshaft are focused.
  1. At the unloaded car adjust distance between the back party of a cover and shaft.
  1. At the unloaded car adjust distances between end faces of basic bearings and end faces of support.
  1. Tighten bolts of fastening of support with effort of 37 Nanometers.
  2. Make sure that axes of support are perpendicular driveshaft axes.


(adsbygoogle121 = window.adsbygoogle121 || []).push({});