LEXUS RX 300

1998 — 2003 of release

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Governing bodies and methods of operation
+ Settings and routine maintenance of the car
+ Engine
+ Cooling systems of the engine, heating, ventilation and air conditioning
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Automatic transmission and interaxal differential
+ Transmission line
+ Brake system
+ Suspension bracket and steering
- Body
   - External equipment and body elements
      Removal and installation of the top strut of a motive compartment
      Removal and installation of bumpers
      Removal and installation of a cowl, its lock and decorative front grille
      Removal, installation, dismantling and assembly of a forward door and its components
      Removal, installation, dismantling and assembly of a back door and its components
      Removal, dismantling, assembly and installation of a door of a back and its components
      Removal and installation of cleaners and fairing of a windshield
      Removal and installation of moldings
      Removal and installation of a spoiler
      Removal and installation of the top hatch
   + Equipment of salon
+ Onboard electric equipment
+ Schematic diagrams of electric connections

2598ff35

Removal and installation of cleaners and fairing of a windshield

Components of installation of a fairing of a windshield

1 — Consolidation between a cowl and a fairing
2 — Assemblies of levers and edges of screen wipers
3 — the Right lattice of a fairing
4 — the Left lattice of a fairing

5 — Э / the motor and drafts of levers of screen wipers
6 — the Socket э / the motor of screen wipers
7 — the windshield fairing Panel


 PERFORMANCE ORDER

  1. Give 3 nuts and remove assemblies of levers and edges of screen wipers.
  2. Paste a protective tape on the lower part of a windshield.
  3. Remove consolidation between a cowl and a fairing.
  4. Remove clips and both lattices of a fairing.
  5. Separate the socket э / the motor of screen wipers.
  1. Turn out 5 bolts and remove э / the motor with drafts of levers of screen wipers.
  1. Give a nut, put adjusting tags, turn out 3 bolts and remove э / the motor from assembly of drafts.
  1. Turn out 9 bolts and remove the fairing panel.
  2. Disconnect hoses from nozzles of washers and remove nozzles.
  3. Installation is made upside-down. Tighten fixture with the required efforts.
  4. In conclusion of installation tighten nuts of fastening of levers of screen wipers by hand and include screen wipers on one cycle. Adjust provisions of levers (see the Section Check of a State, adjustment and replacement of brushes of screen wipers) and tighten nuts with the required efforts.
  5. After installation check that the top points of hit of streams of the washing liquid on glass were in the areas designated on an illustration, and the lower points – in a scope of screen wipers.

Check of nozzles of washers

A — 280 mm
B — 150 mm
With — 10 mm
D — 60 mm


(adsbygoogle121 = window.adsbygoogle121 || []).push({});